美國Glas-Col溫度控制器、數字計時器 104A PC524

簡要描述：

104A PT624美國Glas-Col溫度控制器、數字計時器 104A PC524
temperature control

更新時間：2024-10-06

訪問量：1369

廠商性質：經銷商

生產地址：

在線詢價聯系我們

產品介紹：

104A PT624美國Glas-Col溫度控制器、數字計時器 104A PC524

glas - col的限制控制為實驗室加熱過程提供了安全備份。當在主電源或溫度控制和電源之間安裝時，限制允許溫度過高。操作者簡單地將限值設置為該過程的zui高溫度。如果主電源控制失效，或由于任何原因超過了工藝溫度，限制器將會終止對主控制的功率，從而降低因過熱而損壞樣品、昂貴設備和玻璃器皿的機會。

104A PT624美國Glas-Col溫度控制器、數字計時器 104A PC524

RAMPTROL

Glas-Col’s LimiTrol limiting control provides a safety backup for laboratory heating processes. When installed between the primary power or temperature control and the power source, the LimiTrol allows for over-temperature limiting. The operator simply sets the LimiTrol to the maximum temperature for the process. Should the primary power control fail, or the process temperature be exceeded for any reason, the LimiTrol will terminate power to the primary control, thus reducing the chance of damage to samples, expensive equipment, and glassware due to overheating. The unit features a manual reset, which means power will remain off until the operator restores the system. The set-point dial is calibrated in 20° C increments, and the load and thermocouple receptacles are located on the back panel for easy access. Furnished with a type J immersion thermocouple with 6"-long stainless steel probe.

104A PT624

Specifications

Electrical: Lighted on/off power switch with auxiliary LED indication, fuse protection,3-wire load receptacle, 3-wire line cord with molded plug Set Point Accuracy: ± 3% of span maximum.

Lab Bench Case: 8"w x 6"d x 3-3/8"h.

DIGITAL TIMER

The Glas-Col Digital Timer is a micro controller-based countdown interval timer with digital display. For use with mantles,heating tapes, ovens, and other resistive loads up to 10 amps. Also can be used with stirrers, vortexers, shakers, and other motor-driven laboratory equipment up to 10 amps load capacity.Four timing ranges may be selected from the front panel. At the completion of the timing cycle, a solid-state alarm will sound for 5 seconds. The power to the load receptacle is terminated at the end of the timing cycle. The timer will then reset to the preset starting time. The timing cycle may be interrupted by pushing the start/stop button.Timing will resume from the stopping point when timing cycle is restarted.